![]() ![]() I got a PDF manual on line but it was pretty much usless. Finally, there is a micro adjustment on it where you press in the knob and turn it to adjust it, however the gear on the knob is about 1/4" below the teeth it is supposed to make contact with and I can not see any way to correct it. Is there any way to adjust this so I don't have to fight with it?ģ. I also notice that when I lock it down that the back end is not aligned with the front so it is cockeyed. What is odd is if I put my tape measure along it, they both match up. If it is more then 10" then it is off by as much a 1/8". If it is 10' or less from the blade then the built in tape measure is accurate. While I am one to use a measuring tape to make sure the cut is right, I noticed a couple of things with this fence.ġ. My only complaint is the Exact-I-Rip Fence. Also put a linked belt on it to stop vibration and upgraded the motor. I put it together and spent a lot of time tuning it up and making sure the blade was parralell to the miter slot. I have a 20 year old Craftsman table saw with the Exact-I-Rip Fence on it that was given to me. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |